This is a side mounted water pail/bucket holder for RuffLand Kennels. It fits Backseat Rider, Intermediate, Large, and XL. It has an adjustable thumb screw to securely tighten against the holes in the side of the kennel so it wont come out unless you want it to. It also has 2 detents inside the pail clip to securely hold both the thick and thin handled buckets. The bucket won’t easily get knocked out of the hook. We prioritize safety over all else! This is designed to be near impossible for a dog to pull it into the kennel with minimal plastic sticking inside the kennel and soft edges to limit chewing.
This is 3D printed with PETG plastic that has natural UV resistance so the color won’t fade and the plastic won’t degrade over time, even in direct sunlight. It also has great thermal resistance so it won’t get soft and deform if left outside or in a hot car like PLA will. It sticks out from the kennel less than an inch.
There are several colors to choose from. If you don’t see a color listed that you’d like, send a message and inquire about it. We may be able to order filament in your desired color. The bolt/hardware is also available in black oxide coated stainless steel or in bare silver stainless steel. No rusting here!
To install:
– Turn the thumb screw according to the “OFF” arrow until the adjuster bottoms out.
– Slip the top of the clip in the desired hole then rock the bottom into the hole.
– Turn the thumb screw according to the “ON” arrow until it is really tight and you can’t turn it anymore.
– Clip the pail into the hook. It is easier to angle the bucket left or right and install the handle in a rocking motion rather than straight down. (Its a tight fit to keep it secure).
***DISCLAIMER***
– These are printed in black PETG plastic. This plastic can start to get soft at temperatures of 190*F. Even in extreme environments this shouldn’t be an issue. PETG parts have been used in vehicles and outdoors for long periods of time without negative effects.
– This is a 3D printed part, this means not all parts will appear or fit exactly the same. I do not accept returns due to it being made to order, however If you have an issue with your part, please contact me and we can work out the issue together.
– If you break it due to over-tightening a screw or through use, you can fix it with some super glue or you can message me to purchase a replacement part.
– This is a made to order part so please allow time for printing, processing, and shipping.
– Shipping damage must be reported within 3 days of receiving the item. After this time a return/refund will not be accepted nor will a replacement part be sent out due to shipping damage.
