This is a kit of 2 bucket seat lever trims for the bucket seats in the 1984-1996 Jeep Cherokee XJ and 1986-1992 Jeep Comanche MJ. These are primarily found in 2 door Jeeps but at this point could be found in many Jeeps as the seats are swapped around. These are located just below the headrest on the door side of the seat. These can be made in any of the available colors, other than black, none of them are going to be an exact match to the other interior plastics although the space gray is pretty close. These can also be painted to match.
THE LEVER KNOB IS ALSO AVAILABLE, CHECK OUR LISTINGS FOR IT!
INSTALLATION:
1. Remove the roll pin from the seat adjust lever and pull it off.
2. Remove the two screws attaching the old trim and slide it out of the seat.
3. Slide the new trim into the seat and reinstall the screws. Don’t over tighten them!
4. Slide the knob back onto the lever and reinstall the roll pin.
***DISCLAIMER***
– These are printed in black PETG plastic. This plastic has natural UV resistance so the color won’t fade over time and won’t get brittle. This plastic can start to get soft at temperatures of 190*F. Even in extreme environments this shouldn’t be an issue. PETG parts have been used on vehicles for long periods of time without ill effects.
– This is a 3D printed part, this means not all parts will appear or fit exactly the same. We do not accept returns due to it being made to order, however If you have an issue with your part, please contact me and we can work out the issue together.
– If you break it due to not following instructions, over-tightening screws, or through use, you can fix it with some super glue or you can message me to purchase a replacement part.
– This is a made to order part. We print and ship as soon as possible, please allow ample time for me to process and ship.
– Shipping damage must be reported within 3 days of receiving the item. After this time a return/refund will not be accepted nor will a replacement part be sent out due to shipping damage.
