1986-1992 Jeep Comanche tail light adapters to fit 2007-2018 Jeep Wrangler JK tail lights. This will fit any aftermarket or factory JK tail light as long as the light uses that outer trim piece (I haven’t seen any that don’t have that). They fit nicely in the truck and offer an affordable alternative to replacing your broken tail lights. They stick out on the bedsides of the truck slightly, just like they do on a Wrangler tub. This is the adapter kit only, lights not included!
These are 3D printed in black PETG, which has great UV and environmental resistance. These can be installed as is or you can do a light sanding and finish them with some filler primer and paint. These are a printed in two pieces and lock together to make the adapter as seen in the pictures.
Please be aware that these are designed to fit snuggly in a factory truck, I have found through test fitting that not all trucks are exactly the same and you MIGHT need to do some sanding around the edges to make them fit nicely in your truck, especially if you have repainted the truck. Use a foam block sander and sandpaper by hand to do any fitting, DO NOT use any powered sander or Dremel as they will take material off way too quickly.
This kit includes adapters for both sides of the truck and 12 screws for mounting. You will need to retain 4 of your factory MJ tail light screws for the outsides of the mounts.
INSTALLATION:
1. Clip the two pieces of each adapter together. They are labeled for which side they go on.
2. Test fit the adapter, do any sanding required around the outer edges to make them fit nicely in your truck.
3. Remove the screws holding the outer trim piece on your JK lights if it is still attached.
4. Put the JK lights in the adapters and put 4 of the included screws into each light to attach them to the adapter. Tighten until they are just snug, don’t overtighten them. (USE A HAND SCREWDRIVER ONLY, NO POWER TOOLS!)
5. Put the assembled adapters in the truck and use 2 of the provided screws on the tailgate side of each adapter and 2 of the factory MJ screws on the bedside of the adapters.
6. Remove them to adapt/splice your wiring and do any finishing work you would like to do.
7. Keep or sell your extra factory MJ screws and tail lights. Even if they are broken someone will buy them as they are getting expensive and hard to find.
***DISCLAIMER***
– These are printed in black PETG plastic. This plastic can start to get soft at temperatures of 190*F. Even in extreme environments this shouldn’t be an issue. PETG parts have been used on vehicles for long periods of time without Ill effects.
– This is a 3D printed part, this means not all parts will appear or fit exactly the same. It is set to print as fast as possible due to the long print times and I’m trying to keep prices low, this results in a slightly lower resolution print however I will never send a part out that doesn’t look good or function properly. I do not accept returns due to it being made to order, however If you have an issue with your part, please contact me and we can work out the issue together.
– If you break it due to not following instructions, over-tightening screws, or through use, you can fix it with some super glue or you can message me to purchase a replacement part.
– This is a made to order part and takes over 60 hours to print if all goes well. I print and ship as soon as possible but due to the long print time, please allow ample time for me to process and ship.
– Shipping damage must be reported within 3 days of receiving the item. After this time a return/refund will not be accepted nor will a replacement part be sent out due to shipping damage.