Skip to content

Beehive Frame Holder Set (Pair)

$12.00

SKU: 1052.100 & 1052.200 Category:

This is a set of 3D printed beehive frame holders so you can tend your bees easily!  These brackets clip onto a standard Langstroth hive to hold the frames up off the ground and in the proper orientation while you work the bees.  They are small enough to fit in your pocket or in the toolbox.  These are also made with PETG plastic so they will easily survive those hot days in the back of your truck or car.

There are 2 sizes of hanger available to allow holding either 2 or 3 frames.   They are designed to slide onto standard 3/4″ thick boards but they do have a flexible clip so they will fit slightly thicker wood.  These are also long enough to hang securely on any boards thinner than 3/4″ as well.

To use the brackets, simply use the arrows and left/right markings to determine which side they go on, then slide them down onto the corners of the brood box or super.  Set the frames on the brackets to work the bees.  When finished, just replace the frames in the hive and slide the brackets up and off the hive.

***DISCLAIMER***

– These are printed in black PETG plastic.  This plastic can start to get soft at temperatures of 190*F.  Even in extreme environments this shouldn’t be an issue.  PETG parts have been used in vehicles for long periods of time without negative effects.

– This is a 3D printed part, this means not all parts will appear or fit exactly the same.  It is set to print as fast as possible due to the long print times and I’m trying to keep prices low, this results in a slightly lower resolution print however I will never send a part out that doesn’t look good or function properly.  I do not accept returns due to it being made to order, however If you have an issue with your part, please contact me and we can work out the issue together.

– If you break it due to over-tightening a screw or through use, you can fix it with some super glue or you can message me to purchase a replacement part.

– This is a made to order part so please allow time for printing, processing, and shipping.

– Shipping damage must be reported within 3 days of receiving the item.  After this time a return/refund will not be accepted nor will a replacement part be sent out due to shipping damage.